Mô tả ngắn gọn
| I/O module | 4 full-bridge strain gauge inputs |
Thông tin chung
| B&R ID code | 0xE286 |
| Chỉ số trạng thái | Channel status, trạng thái hoạt động, module status |
| Chẩn đoán | |
| Chạy mô-đun/lỗi | Yes, using LED status indicator and software |
| Open circuit | Yes, using LED status indicator and software |
| Input | Yes, using LED status indicator and software |
| Tiêu thụ điện năng | |
| Bus | 0.01 W |
| Internal I/O | 1 W |
| Tiêu tán công suất bổ sung do bộ truyền động gây ra (resistive) [W] | +1.43 |
| Chứng nhận | |
| CE | Yes |
| UKCA | Yes |
| ATEX |
Zone 2, II 3G Ex nA nC IIA T5 Gc IP20, Ta (see X20 user’s manual) FTZÚ 09 ATEX 0083X |
| UL |
cULus E115267 Thiết bị điều khiển công nghiệp |
Full-bridge strain gauge
| Strain gauge factor | 2 to 256 mV/V, configurable using software |
| Connection | 4-wire connections |
| Kiểu đầu vào | Differential, used to evaluate a full-bridge strain gauge |
| Độ phân giải chuyển đổi kỹ thuật số | 24-bit |
| Thời gian chuyển đổi | 200 µs |
| Data output rate | 5000 samples per second and per channel (fDATA) |
| Bộ lọc đầu vào | |
| Cutoff frequency | 2.5 kHz |
| Order | 3 |
| Slope | 60 dB |
| ADC filter characteristics | Sigma-delta, see section “Filter” |
| Operating range / Measurement sensor | 85 to 5000 Ω |
| Influence of cable length | Twisted and shielded conductors, cable length as short as possible, cable routing separate from load circuits, without intermediate terminal to sensor |
| Bảo vệ đầu vào | RC protection |
| Common-mode range |
0.6 to 3.8 VDC Permissible input voltage range (with regard to the electric potential strain gauge GND) on inputs “Input +” and “Input -” |
| Insulation voltage between input and bus | 500 Veff |
| Quy trình chuyển đổi | Sigma-delta |
| Output of digital value | |
| Broken bridge supply line | Value approaching 0 |
| Broken sensor line | Value approaching ±end value (status bit “Open circuit” set in register “Module status”) |
| Valid range of values | 0xFF800001 to 0x007FFFFF (-8,388,607 to 8,388,607) |
| Strain gauge supply | |
| Voltage | 5.5 VDC / Max. 65 mA per channel |
| Short-circuit and overload-proof | Yes |
| Quantization | |
| LSB value | |
| 2 mV/V | 1.31 nV |
| 4 mV/V | 2.62 nV |
| 8 mV/V | 5.25 nV |
| 16 mV/V | 10.49 nV |
| 32 mV/V | 20.98 nV |
| 64 mV/V | 41.96 nV |
| 128 mV/V | 83.92 nV |
| 256 mV/V | 167.85 nV |
| Max. gain drift | 35 ppm/°C |
| Max. offset drift | 15 ppm/°C |
| Nonlinearity | <10 ppm |
Tính chất điện
| Cách ly điện |
Bus isolated from analog input and strain gauge supply voltage Channel not isolated from channel and I/O power supply |
Điều kiện hoạt động
| Hướng lắp đặt | |
| Nằm ngang | Yes |
| Thẳng đứng | Yes |
| Độ cao lắp đặt so với mực nước biển | |
| 0 to 2000 m | Không có giới hạn |
| >2000 m | Reduction of ambient temperature by 0.5°C per 100 m |
| Mức độ bảo vệ mỗi EN 60529 | IP20 |
Điều kiện môi trường xung quanh
| Nhiệt độ | |
| Hoạt động | |
| Nằm ngang mounting orientation | -25 to 60°C |
| Thẳng đứng mounting orientation | -25 to 50°C |
| Giảm tải | See section “Phần cứng configuration” |
| Lưu trữ | -40 to 85°C |
| Transport | -40 to 85°C |
| Độ ẩm tương đối | |
| Hoạt động | 5 to 95%, non-condensing |
| Lưu trữ | 5 to 95%, non-condensing |
| Transport | 5 to 95%, non-condensing |
Tính chất cơ học
| Note |
Order 1x cầu đấu X20TB1F separately. Order 1x bus module X20BM11 separately. |
| Pitch | 12.5+0.2 mm |



