Mô tả ngắn gọn
I/O module | 1 full-bridge strain gauge input |
Thông tin chung
B&R ID code | 0xA4EF |
Chỉ số trạng thái | Channel status, trạng thái hoạt động, module status |
Chẩn đoán | |
Chạy mô-đun/lỗi | Yes, using LED status indicator and software |
Open circuit | Yes, using LED status indicator and software |
Input | Yes, using LED status indicator and software |
Tiêu thụ điện năng | |
Bus | 0.01 W |
Internal I/O | 0.5 W |
Tiêu tán công suất bổ sung do bộ truyền động gây ra (resistive) [W] | Max. +0.36 |
Chứng nhận | |
CE | Yes |
UKCA | Yes |
ATEX |
Zone 2, II 3G Ex nA nC IIA T5 Gc IP20, Ta (see X20 user’s manual) FTZÚ 09 ATEX 0083X |
UL |
cULus E115267 Thiết bị điều khiển công nghiệp |
HazLoc |
cCSAus 244665 Process control equipment for hazardous locations Class I, Division 2, Groups ABCD, T5 |
KC | Yes |
Full-bridge strain gauge
Strain gauge factor | 2 to 256 mV/V, configurable using software |
Connection | 4- or 6-wire connections |
Kiểu đầu vào | Differential, used to evaluate a full-bridge strain gauge |
Độ phân giải chuyển đổi kỹ thuật số | 24-bit |
Conversion time | Depends on the configured data output rate |
Data output rate | 0.1 – 7500 samples per second, configurable using software (fDATA) |
Bộ lọc đầu vào | |
Cutoff frequency | 5 Hz |
Order | 3 |
Slope | 60 dB |
ADC filter characteristics | Sigma-delta, see section “Filter characteristics of the sigma-delta A/D converter” |
Operating range / Measurement sensor | 85 to 5000 Ω |
Influence of cable length | See section “Calculation example”. |
Bảo vệ đầu vào | RC protection |
Common-mode range |
0 to 3 VDC Permissible input voltage range (with regard to the electric potential strain gauge GND) on inputs “Input +” and “Input -” |
Insulation voltage between input and bus | 500 Veff |
Quy trình chuyển đổi | Sigma-delta |
Output of digital value | |
Broken bridge supply line | Value approaching 0 |
Broken sensor line | Value approaching ±end value (status bit “Line monitoring” is set in register “Module status”) |
Valid range of values | 0xFF800001 to 0x007FFFFF (-8,388,607 to 8,388,607) |
Strain gauge supply | |
Voltage | 5.5 VDC / Max. 65 mA |
Short-circuit and overload-proof | Yes |
Voltage drop for short-circuit protection | Max. 0.2 VDC at 65 mA and 25°C |
Quantization | |
LSB value (16-bit) | |
2 mV/V | 336 nV |
4 mV/V | 671 nV |
8 mV/V | 1.343 µV |
16 mV/V | 2.686 µV |
32 mV/V | 5.371 μV |
64 mV/V | 10.74 μV |
128 mV/V | 21.48 μV |
256 mV/V | 42.97 μV |
LSB value (24-bit) | |
2 mV/V | 1.31 nV |
4 mV/V | 2.62 nV |
8 mV/V | 5.25 nV |
16 mV/V | 10.49 nV |
32 mV/V | 20.98 nV |
64 mV/V | 41.96 nV |
128 mV/V | 83.92 nV |
256 mV/V | 167.85 nV |
Nhiệt độ coefficient | |
Rev. ≥E0 | 10 ppm/°C |
Rev. <E0 | 30 ppm/°C |
Max. gain drift | 12 ppm/°C |
Max. offset drift | 2 ppm/°C |
Nonlinearity | <10 ppm |
Tính chất điện
Cách ly điện |
Bus isolated from analog input and strain gauge supply voltage Channel not isolated from I/O power supply |
Điều kiện hoạt động
Hướng lắp đặt | |
Nằm ngang | Yes |
Thẳng đứng | Yes |
Độ cao lắp đặt so với mực nước biển | |
0 to 2000 m | Không có giới hạn |
>2000 m | Reduction of ambient temperature by 0.5°C per 100 m |
Mức độ bảo vệ mỗi EN 60529 | IP20 |
Điều kiện môi trường xung quanh
Nhiệt độ | |
Hoạt động | |
Nằm ngang mounting orientation | -25 to 60°C |
Thẳng đứng mounting orientation | -25 to 50°C |
Giảm tải | See section “Phần cứng configuration” |
Lưu trữ | -40 to 85°C |
Transport | -40 to 85°C |
Độ ẩm tương đối | |
Hoạt động | 5 to 95%, non-condensing |
Lưu trữ | 5 to 95%, non-condensing |
Transport | 5 to 95%, non-condensing |
Tính chất cơ học
Note |
Order 1x cầu đấu X20TB12 separately. Order 1x bus module X20BM11 separately. |
Pitch | 12.5+0.2 mm |