Mô tả ngắn gọn
| I/O module | 1 full-bridge strain gauge input |
Thông tin chung
| B&R ID code | 0xF1A7 |
| Chỉ số trạng thái | Channel status, trạng thái hoạt động, module status |
| Chẩn đoán | |
| Chạy mô-đun/lỗi | Yes, using LED status indicator and software |
| Open circuit | Yes, using LED status indicator and software |
| Input | Yes, using LED status indicator and software |
| Tiêu thụ điện năng | |
| Bus | 0.01 W |
| Internal I/O | 0.65 W |
| Tiêu tán công suất bổ sung do bộ truyền động gây ra (resistive) [W] | Max. +0.68 |
| Chứng nhận | |
| CE | Yes |
| UKCA | Yes |
| ATEX |
Zone 2, II 3G Ex nA nC IIA T5 Gc IP20, Ta (see X20 user’s manual) FTZÚ 09 ATEX 0083X |
| UL |
cULus E115267 Thiết bị điều khiển công nghiệp |
Full-bridge strain gauge
| Strain gauge factor | 2 to 256 mV/V, configurable using software |
| Connection | 4- or 6-wire connections |
| Kiểu đầu vào | Differential, used to evaluate a full-bridge strain gauge |
| Độ phân giải chuyển đổi kỹ thuật số | 24-bit |
| Conversion time | Depends on the configured data output rate |
| Data output rate | 0.1 – 7500 samples per second, configurable using software (fDATA) |
| Bộ lọc đầu vào | |
| Cutoff frequency | 5 kHz |
| Order | 3 |
| Slope | 60 dB |
| ADC filter characteristics | Sigma-delta, see section “Filter characteristics of the sigma-delta A/D converter” |
| Operating range / Measurement sensor | 162 to 5000 Ω |
| Influence of cable length | See section “Calculation example”. |
| Bảo vệ đầu vào | RC protection |
| Common-mode range |
0 to 3 VDC Permissible input voltage range (with regard to the electric potential strain gauge GND) on inputs “Input +” and “Input -” |
| Insulation voltage between input and bus | 500 Veff |
| Quy trình chuyển đổi | Sigma-delta |
| Output of digital value | |
| Broken bridge supply line | Value approaching 0 |
| Broken sensor line | Value approaching ±end value (status bit “Line monitoring” is set in register “Module status”) |
| Valid range of values | 0xFF800001 to 0x007FFFFF (-8,388,607 to 8,388,607) |
| Strain gauge supply | |
| Voltage | 10.5 VDC / Max. 65 mA |
| Short-circuit and overload-proof | Yes |
| Voltage drop for short-circuit protection | Max. 0.2 VDC at 65 mA and 25°C |
| Quantization | |
| LSB value (16-bit) | |
| 2 mV/V | 641 nV |
| 4 mV/V | 1.28 µV |
| 8 mV/V | 2.56 µV |
| 16 mV/V | 5.13 µV |
| 32 mV/V | 10.25 μV |
| 64 mV/V | 20.51 μV |
| 128 mV/V | 41.02 μV |
| 256 mV/V | 82.03 μV |
| LSB value (24-bit) | |
| 2 mV/V | 2.50 nV |
| 4 mV/V | 5.01 nV |
| 8 mV/V | 10.01 nV |
| 16 mV/V | 20.03 nV |
| 32 mV/V | 40.05 nV |
| 64 mV/V | 80.11 nV |
| 128 mV/V | 160.22 nV |
| 256 mV/V | 320.43 nV |
| Nhiệt độ coefficient | |
| Rev. ≥E0 | 10 ppm/°C |
| Rev. <E0 | 30 ppm/°C |
Tính chất điện
| Cách ly điện |
Bus isolated from analog input and strain gauge supply voltage Channel not isolated from I/O power supply |
Điều kiện hoạt động
| Hướng lắp đặt | |
| Nằm ngang | Yes |
| Thẳng đứng | Yes |
| Độ cao lắp đặt so với mực nước biển | |
| 0 to 2000 m | Không có giới hạn |
| >2000 m | Reduction of ambient temperature by 0.5°C per 100 m |
| Mức độ bảo vệ mỗi EN 60529 | IP20 |
Điều kiện môi trường xung quanh
| Nhiệt độ | |
| Hoạt động | |
| Nằm ngang mounting orientation | -25 to 60°C |
| Thẳng đứng mounting orientation | -25 to 50°C |
| Giảm tải | See section “Phần cứng configuration” |
| Lưu trữ | -40 to 85°C |
| Transport | -40 to 85°C |
| Độ ẩm tương đối | |
| Hoạt động | 5 to 95%, non-condensing |
| Lưu trữ | 5 to 95%, non-condensing |
| Transport | 5 to 95%, non-condensing |
Tính chất cơ học
| Note |
Order 1x cầu đấu X20TB12 separately. Order 1x bus module X20BM11 separately. |
| Pitch | 12.5+0.2 mm |



